Power Saving Tips For Refrigerators

Refrigerator placement

The location of the refrigerator should be chosen to avoid direct sunlight, facilitate ventilation, and keep a distance from the wall so that the heat generated during the operation of the refrigerator can be dissipated.

Check tightness

Always check the sealing of the refrigerator seal. If the seal is deformed, it will affect the tightness of the closure and cause the leakage of air-conditioning, thereby increasing power consumption. If the deformation is serious, it should be repaired and replaced in time.

Defrost regularly

After the refrigerator is used for a period of time, some frost will occur. If it cannot be defrosted regularly, it will affect the refrigeration effect, and the power consumption will increase, and it may even damage the compressor. Therefore, whenever the thickness of frost is more than 7cm, it should be defrosted.

Reduce the number of door openings

Whenever you open the door once, cold air will be exposed and hot air will invade, so you have to run the compressor again for cooling. Therefore, try to take out the various ingredients you need at once, and move quickly, and the door of the box should not be opened too wide to reduce the loss of air-conditioning as much as possible.

If you don’t have any stocks, don’t leave the refrigerator empty, as it will consume a lot of electricity. A better way is to put a few small basins of water inside and let it freeze, which can help keep the temperature low and reduce energy consumption.

Refrigerator deodorization

Lemon deodorization: Cut the lemon into small pieces and place them on each floor of the refrigerator to remove the peculiar smell.

Charcoal deodorization: crush an appropriate amount of charcoal, put it in a small cloth bag, and put it in the refrigerator. The deodorization effect is very good.

Put 500 grams of baking soda powder into two empty bottles, and then put the bottles on the upper and lower layers of the refrigerator; after 24 hours, all kinds of peculiar smells in the refrigerator can be removed. Wet it with a clean cotton towel, wring it dry, fold it and place it on the side of the grid on the upper layer of the refrigerator compartment. Through air convection, it can absorb the odor in the refrigerator. After using it for a period of time, Wash the towel and warm water to continue using.