Refrigerator Water, Running Water Problem
Henan Moonpaint Refrigeration Equipment Co., Ltd.
If it is water droplets, it is because there is an evaporator in the back wall of the refrigerator compartment. When the compressor is working, the evaporator is used to cool down, so the temperature is very low, and frost will occur. After the compressor is shut down,
The frost will slowly melt to form water droplets, and then flow into the water receiving box under the rear wall of the refrigerator, flow into the water receiving box above the compressor through the drain hole, and then slowly evaporate through the temperature of the compressor.
If it is water, then the reasons are as follows:
1. The number of times of opening the door is too frequent, causing a large amount of hot air to enter the refrigerator, and the hot air will produce condensed water during condensation, and the generation of condensed water is greater than the rate of discharge, which will cause water accumulation.
2. Is the position of the thermostat knob normal? Sometimes when we place food, we accidentally turn the thermostat knob without knowing it.
Thermostat knob adjustment method: The refrigerator temperature control knob generally has 0, 1, 2, 3, 4, 5, 6, 7, and the larger the number, the lower the temperature in the freezer. Generally in spring and autumn, we put it on the 3rd gear, specifically depends on your requirements, whether the freezer can reach below minus 18 degrees. In order to achieve the purpose of food preservation and power saving, we can switch to gear 1 or 2 in summer, and gear 4 or 5 in winter.
Some people may ask, if the temperature is low in winter, the temperature is set low (the thermostat value is large), and the temperature is high in summer, but the temperature is set high (the thermostat value is small), is it wrong?
In fact, many people have such a misunderstanding that the temperature of the refrigerator can be set higher in winter when the temperature is low, and lower in summer when the temperature is high.
3. When the food is stored, the temperature is too high and it is directly put into the refrigerator without cooling. The hot air has a large water content. Cooling in the refrigerator will cause a large amount of condensed water. standing water.
4. The drain pipe of the refrigerator is blocked and cannot drain water. 80% of users have this reason to cause water in the refrigerator freezer. This is because the rear wall of the refrigerating compartment of the direct-cooling refrigerator is closely attached to the evaporator of the refrigerating part.
When the compressor unit is working, the evaporator of the refrigerating part absorbs heat from the refrigerating chamber, which reduces the temperature of the rear wall of the refrigerating chamber, resulting in a uniform layer of thin ice or frost on the wall. But when the compressor stops working,
The temperature slowly rises, and the ice on the back wall will gradually melt. The normal working procedure is for the melted water to run down the drain to the drip tray outside the refrigerator, where it evaporates. But if the drain is clogged,
If there is no place for water to flow, it will naturally flow out from the front, which leads to the common situation of running water in the refrigerator room.
